Integration Manual

TOBY-L2 and MPCI-L2 series - System Integration Manual
UBX-13004618 - R04 Advance Information System description
Page 38 of 141
1.9 Data communication interfaces
TOBY-L2 and MPCI-L2 series modules provide the following serial communication interface:
 USB interface: High-Speed USB 2.0 compliant interface available for the communication with an external
host application processor, for AT commands, data communication, FW upgrade by means of the FOAT
feature, FW upgrade by means of the u-blox EasyFlash tool and for diagnostic purpose (see section 1.9.1 for
functional description)
TOBY-L2 series modules additionally provide the following serial communication interfaces:
 UART interface: asynchronous serial interface available for the communication with an external host
application processor, for AT commands, data communication, FW upgrade by means of the FOAT feature
(see section 1.9.2 for functional description)
 DDC interface: I
2
C bus compatible interface available for the communication with u-blox GNSS positioning
chips/modules and with external I
2
C devices as an audio codec (see section 1.9.3 for functional description)
 SDIO interface: Secure Digital Input Output interface available for the communication with an external Wi-Fi
chip or module (see section 1.9.4 for functional description)
1.9.1 Universal Serial Bus (USB)
1.9.1.1 USB features
TOBY-L2 and MPCI-L2 series modules include a High-Speed USB 2.0 compliant interface with maximum data
rate of 480 Mb/s, representing the main interface for transferring high speed data with a host application
processor: the USB interface is available for AT commands, data communication, FW upgrade by means of the
FOAT feature, FW upgrade by means of the u-blox EasyFlash tool and for diagnostic purpose.The module itself
acts as a USB device and can be connected to a USB host such as a Personal Computer or an embedded
application microprocessor equipped with compatible drivers.
The USB_D+ / USB_D- lines carry the USB serial bus data and signaling, providing all the functionalities for the
bus attachment, configuration, enumeration, suspension or remote wakeup according to the Universal Serial Bus
Revision 2.0 specification [6]
The additional VUSB_DET input pin is available on TOBY-L2 series modules as optional feature to sense the USB
VBUS supply (5.0 V typical) from the host, providing the complete bus detach functionality for further reduction
of the module current consumption in particular during low-power idle mode with power saving enabled:
TOBY-L2 series modules disable the USB interface when a low logic level is sensed after a high-to-low logic level
transition on the VUSB_DET input pin, reducing the current consumption.
The VUSB_DET pin is not available on MPCI-L2 series modules.
The USB interface is controlled and operated with:
 AT commands according to 3GPP TS 27.007 [8], 3GPP TS 27.005 [9], 3GPP TS 27.010 [10]
 u-blox AT commands
For the complete list of supported AT commands and their syntax see u-blox AT Commands Manual [3].