Integration Manual

TOBY-L2 and MPCI-L2 series - System Integration Manual
UBX-13004618 - R26 System description
Page 65 of 162
1.15.14 Smart temperature management
Smart temperature management is not supported by “00”, “01” and “60” product versions.
Cellular modules – independent of the specific model – always have a well defined operating temperature range.
This range should be respected to guarantee full device functionality and long life span.
Nevertheless there are environmental conditions that can affect operating temperature, e.g. if the device is located
near a heating/cooling source, if there is/isn’t air circulating, etc.
The module itself can also influence the environmental conditions; such as when it is transmitting at full power. In
this case its temperature increases very quickly and can raise the temperature nearby.
The best solution is always to properly design the system where the module is integrated. Nevertheless an extra
check/security mechanism embedded into the module is a good solution to prevent operation of the device outside
of the specified range.
Smart Temperature Supervisor (STS)
The Smart Temperature Supervisor is activated and configured by a dedicated AT+USTS command. See the u-blox
AT Commands Manual [3] for more details.
The cellular module measures the internal temperature (Ti) and its value is compared with predefined thresholds
to identify the actual working temperature range.
Temperature measurement is done inside the cellular module: the measured value could be different from
the environmental temperature (Ta).
Warning
area
t
-1
t
+1
t
+2
t
-2
Valid temperature range
Safe
area
Dangerous
area
Dangerous
area
Warning
area
Figure 28: Temperature range and limits
The entire temperature range is divided into sub-regions by limits (see Figure 28) named t
-2
, t
-1
, t
+1
and t
+2
.
 Within the first limit, (t
-1
< Ti < t
+1
), the cellular module is in the normal working range, the Safe Area
 In the Warning Area, (t
-2
< Ti < t
.1
) or (t
+1
< Ti < t
+2
), the cellular module is still inside the valid temperature
range, but the measured temperature approaches the limit (upper or lower). The module sends a warning to
the user (through the active AT communication interface), which can take, if possible, the necessary actions
to return to a safer temperature range or simply ignore the indication. The module is still in a valid and good
working condition
 Outside the valid temperature range, (Ti < t
-2
) or (Ti > t
+2
), the device is working outside the specified range
and represents a dangerous working condition. This condition is indicated and the device shuts down to avoid
damage
For security reasons the shutdown is suspended in case an emergency call in progress. In this case the device
will switch off at call termination.
The user can decide at anytime to enable/disable the Smart Temperature Supervisor feature. If the feature
is disabled there is no embedded protection against disallowed temperature conditions.