Integration Manual

TOBY-L2 and MPCI-L2 series - System Integration Manual
UBX-13004618 - R26 Design-in
Page 123 of 162
2.12 TOBY-L2 series module footprint and paste mask
Figure 69 and Table 49 describe the suggested footprint (i.e. copper mask) layout for TOBY-L2 series modules. The
proposed land pattern layout slightly reflects the modules’ pads layout, with most of the lateral pads designed
wider on the application board (1.8 x 0.8 mm) than on the module (1.5 x 0.8 mm).
I1
A
G H J1D F2
K M1 M1 M2
P2
B
G
H
J
O
O
L
N
M1 M1 M3
I1
I1
O
H
J
J
J
E
P3
F1
P1
H
I1
O
I2
I2
F2
Module placement outline
Figure 69: TOBY-L2 series module suggest footprint (application board top view)
Parameter
Value
Parameter
Value
Parameter
Value
A
35.6 mm
H
0.80 mm
M2
5.20 mm
B
24.8 mm
I1
1.50 mm
M3
4.50 mm
D
2.40 mm
I2
1.80 mm
N
2.10 mm
E
2.25 mm
J
0.30 mm
O
1.10 mm
F1
1.45 mm
K
3.15 mm
P1
1.10 mm
F2
1.30 mm
L
7.15 mm
P2
1.25 mm
G
1.10 mm
M1
1.80 mm
P3
2.85 mm
Table 49: TOBY-L2 series module suggest footprint dimensions
The Non Solder Mask Defined (NSMD) pad type is recommended over the Solder Mask Defined (SMD) pad type,
implementing the solder mask opening 50 µm larger per side than the corresponding copper pad.
The suggested paste mask layout for TOBY-L2 series modules slightly reflects the copper mask layout described in
Figure 69 and Table 49, as different stencil apertures layout for any specific pad is recommended:
 Blue marked pads: Paste layout reduced circumferentially about 0.025 mm to Copper layout
 Green marked pads: Paste layout enlarged circumferentially about 0.025 mm to Copper layout
 Purple marked pads: Paste layout one to one to Copper layout
The recommended solder paste thickness is 150 µm, according to application production process requirements.
These are recommendations only and not specifications. The exact mask geometries, distances and stencil
thicknesses must be adapted to the specific production processes (e.g. soldering etc.) of the customer.