Integration Manual

NORA-B1 series - System integration manual
UBX-20027617 - R04 Regulatory information and requirements Page 46 of 61
C1-Public
• IEEE 802.15.4 based protocols, such as Thread and Zigbee, use (at the MAC layer) a combination
of 16- and 64-bit addresses. The 16-bit (‘short’) address can be used to reduce overhead in
communications. However, each device must have a 64-bit (‘extended’) address and can always
be accessed using this address. Because of this no additional effort is needed when using an
802.15.4 based protocol.
• Protocols based on the 2.4 GHz proprietary mode do not necessarily follow any standards, so
there is no guarantee that the 48-bit addressing requirement will be fulfilled. If the end-product
can be connected to, or accessed through, a public network using a proprietary protocol, it is the
end-product manufacturer’s responsibility to make sure that the protocol uses at least 48-bit
addressing.
⚠ Failure to comply with these requirements will void the NORA-B1 Japan certification, and it will
be illegal to place the end-product on the Japanese market.
6.3.3 End-product labelling requirement
When a product integrating a NORA-B1 series module is placed on the Japanese market the product
must be affixed with a label with the “Giteki” marking as shown in Figure 13. The marking must be
visible for inspection.
Figure 13: Giteki mark, R and the NORA-B1 MIC certification number
☞ The required minimum size of the Giteki mark is Ø3.0 mm.
6.3.4 End-product user manual requirement
As the MIC ID is not included on the NORA-B1 series label, the end-product manufacturer must
include a copy of the NORA-B1 Japan Radio Certificate to the end-product technical documentation.
Contact the u-blox support team in your area to obtain a copy of the NORA-B1 Japan Radio
Certificate (see the Contact page at the end of this document.
6.4 NCC – Taiwanese market (pending)
6.4.1 Compliance statements
• 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、 加大功率或變
更原設計之特性及功能。
• 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至
無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法
通信或工業、科學及醫療用電波輻射性電機設備之干擾。
Statement translation:
• Without permission granted by the NCC, any company, enterprise, or user is not allowed to
change frequency, enhance transmitting power, or alter original characteristic as well as
performance to an approved low power radio-frequency device.
• The low power radio-frequency devices shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating immediately until no interference is
achieved. The said legal communications means radio communications is operated in
compliance with the Telecommunications Act. The low power radio-frequency devices must be
susceptible with the interference from legal communications or ISM radio wave radiated devices.
TBD-TBDTBD