Integration Manual

NORA-B1 series - System integration manual
UBX-20027617 - R04 Regulatory information and requirements Page 45 of 61
C1-Public
In case, where the final product will be installed in locations where the end user is unable to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end-
product manual.
6.2.6.2 Canadian market
The NORA-B1 module is certified for use in Canada under Innovation, Science and Economic
Development Canada (ISED) Radio Standards Specification (RSS) RSS-247 Issue 2 and RSSGen.
The host product shall be properly labelled to identify the modules within the host product.
The Innovation, Science and Economic Development Canada certification label of a module shall be
clearly visible at all times when installed in the host product; otherwise, the host product must be
labelled to display the Innovation, Science and Economic Development Canada certification number
for the module, preceded by the word “Contains” or similar wording expressing the same meaning,
such as:
Le périphérique hôte final, dans lequel ce module RF est intég“é "doit être étiqueté avec
u
45
tiquettette auxiliaire indiquant le CI du module RF, tel que
6.3 MIC - Japanese market (pending)
6.3.1 Compliance statement
NORA-B1 series modules comply with the Japanese Technical Regulation Conformity Certification
of Specified Radio Equipment (ordinance of MPT N°. 37, 1981), Article 2, Paragraph 1:
• Item “9 "2.4 GHz band wide band low power data communication system".
6.3.2 48-bit address requirement
Radio devices on the Japanese market, which can be connected directly or indirectly to a public
network, must have an at least 48-bit (12 hex) long ID code. In practice this means that the device
addresses used in the radio communication protocol (Bluetooth, Thread, Zigbee, Gazell etc.) must be
at least 48 bits.
☞ Note that this requirement is not applicable to devices only intended for use in private or
personal networks.
The requirements on a NORA-B1 design depend on the used radio protocol(s):
• The Bluetooth protocol uses 48-bit addressing, no additional effort is needed.
Contains transmitter module IC: 8595A-NORAB1
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
Contient le module émetteur IC: 8595A-NORAB1
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L' appareil ne doit pas produire de brouillage;
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre lefonctionnement.