Integration Manual
Table Of Contents
- Document information
- Contents
- 1 System description
- 1.1 Overview
- 1.2 Applications
- 1.3 Architecture
- 1.4 Pin assignments
- 1.5 Supply interfaces
- 1.6 System function interfaces
- 1.7 Debug
- 1.8 GPIO pins
- 1.9 Analog interfaces
- 1.10 Serial interfaces
- 1.10.1 Universal Asynchronous Receiver/Transmitter (UART)
- 1.10.2 Serial Peripheral Interface (SPI)
- 1.10.3 Quad Serial Peripheral Interface (QSPI)
- 1.10.4 Inter-Integrated Circuit (I2C) interface
- 1.10.5 Pulse Width Modulation (PWM) interface
- 1.10.6 Inter-IC Sound (I2S) interface
- 1.10.7 Pulse Density Modulation (PDM) interface
- 1.10.8 USB 2.0 device interface
- 1.11 Antenna interface
- 1.12 Reserved pins (RSVD)
- 1.13 GND pins
- 2 Software
- 3 Flashing application software
- 4 Design-in
- 5 Handling and soldering
- 6 Regulatory information and requirements
- 6.1 ETSI – European market
- 6.2 FCC/ISED – US/Canadian markets
- 6.3 MIC - Japanese market (pending)
- 6.4 NCC – Taiwanese market (pending)
- 6.5 KCC – South Korean market (pending)
- 6.6 ANATEL Brazil compliance (pending)
- 6.7 Australia and New Zealand regulatory compliance (pending)
- 6.8 South Africa regulatory compliance (pending)
- 6.9 Integration checklist
- 6.10 Pre-approved antennas list
- 7 Technology standards compliance
- 8 Product testing
- Appendix
- A Glossary
- B Antenna reference designs
- Related documents
- Revision history
- Contact
NORA-B1 series - System integration manual
UBX-20027617 - R04 Design-in Page 35 of 61
C1-Public
4.8.2 Module placement
⚠ Care should be taken not to place components close to the antenna area. Designers should
carefully follow the recommendations from the antenna manufacturer about the distance of the
antenna versus other parts of the system. Designers should also maximize the distance of the
antenna to high-frequency buses like SPI and related components. Otherwise, consider an
optional metal shield to reduce interferences that could be picked up by the antenna and
subsequently reduce sensitivity in the module.
• An optimized module placement allows better RF performance. For more information about
other antenna considerations during module placement, see also Antenna interface.