Product Info

NINA-B4 series - Application note
UBX-20037320 - R03 Contents Page 12 of 19
C1-Public
In cases where the final product is to be installed in locations where the end-user is unable to see the
Anatel logo, NINA-B4 Homologation number and/or statement, these graphical and textual elements
must be included in the end-product manual.
2.8 Australia and New Zealand regulatory compliance
⚠
Approvals are pending.
The NINA-B4 module is compliant with the standards made by the Australian
Communications and Media Authority (ACMA).
The modules are compliant with AS/NZS 4268:2012 standard – Radio equipment and systems – Short
range devices – Limits and methods of standard measurement. The test reports for NINA-B4 modules
can be used as part of the product certification and compliance folder. For more information on the
test reports, email the respective support team at the local mail address in your region. See Contact .
To meet the overall Australian and/or New Zealand end-product compliance standards, the integrator
must create a compliance folder containing all the relevant compliance test reports such as RF, EMC,
electrical safety and DoC (Declaration of Conformity). It is the responsibility of the integrator to know
what is required in the compliance folder for ACMA compliance.
For more information on Australia compliance, refer to the Australian Communications and Media
Authority web site http://www.acma.gov.au/.
For more information on New Zealand compliance, refer to the New Zealand Radio Spectrum
Management Group web site www.rsm.govt.nz.
2.9 South Africa regulatory compliance
⚠
Approvals are pending.
NINA-B4 series modules are compliant and certified by the Independent Communications Authority
of South Africa (ICASA). End-products that are made available for sale or lease or supplied in any
other manner in South Africa shall have a legible label permanently affixed to its exterior surface. The
label shall include the ICASA logo and the ICASA issued license number, as shown in the figure below.
The minimum width and height of the ICASA logo shall be 3 mm. The approval labels must be
purchased by the customer’s local representative directly from the approval authority ICASA. A
sample of a NINA-B4 ICASA label is shown below:
More information on registration as a Responsible Integrator and labeling requirements can be found
at the following website:
Independent Communications Authority of South Africa (ICASA) web site - https://www.icasa.org.za
APPROVED
xx-xxxx/yyyy