User's Manual

NINA-B1 series - Data Sheet
UBX-15019243 - R05 Early Production Information Qualification and approvals
Page 24 of 35
6.4.4 Labeling requirements for end product
For an end product using the NINA-B1 modules there must be a label containing, at least, the following
information:
This device contains
FCC ID: XPYNINAB1
IC: 8595A-NINAB1
The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection in
compliance with the modular approval guidelines developed by the FCC.
In accordance with 47 CFR § 15.19, the end product shall bear the following statement in a conspicuous
location on the device:
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation."
When the device is so small or for such use that it is not practicable to place the statement above on it, the
information shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user
or, alternatively, shall be placed on the container in which the device is marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the FCC ID
and/or this statement, the FCC ID and the statement shall also be included in the end-product manual.
6.4.5 FCC and IC IDs
Model
FCC ID
IC ID
NINA-B111
XPYNINAB1
8595A-NINAB1
NINA-B112
XPYNINAB1
8595A-NINAB1
Table 19: FCC and IC IDs for different models of the NINA-B1 series modules
6.5 NCC Taiwan compliance
6.5.1 Taiwan NCC Warning Statement
 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、 加大功率
或變更原設計之特性及功能。
 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改
善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須
忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
Statement translation:
 Without permission granted by the NCC, any company, enterprise, or user is not allowed to change
frequency, enhance transmitting power or alter original characteristic as well as performance to a
approved low power radio-frequency devices.
 The low power radio-frequency devices shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating immediately until no interference is achieved.
The said legal communications means radio communications is operated in compliance with the
Telecommunications Act. The low power radio-frequency devices must be susceptible with the
interference from legal communications or ISM radio wave radiated devices.