User's Manual

NINA-B1 series - Data Sheet
UBX-15019243 - R05 Early Production Information Qualification and approvals
Page 22 of 35
6 Qualification and approvals
6.1 Compliance with the RoHS directive
The NINA-B1 series modules comply with the "Directive 2011/65/EU of the European Parliament and
the Council on the Restriction of Use of certain Hazardous Substances in Electrical and Electronic
Equipment" (RoHS).
No natural rubbers, hygroscopic materials, or materials containing asbestos are employed.
6.2 European Union regulatory compliance
The NINA-B1 series modules conform to the product specifications listed in Table 18. See the NINA-B1
Declaration of Conformity [4] for more information.
Category
Standard
R&TTE Directive 1999/5/EC
Effective use of frequency spectrum
EN 300 328 V1.9.1
EN 302 291-1
EN 302 291-2
EMC
EN 301 489-1
EN 301 489-3
EN 301 489-17
Health and safety
EN 60950
Medical Electrical Equipment
EN 60601-1-2
Prevention (RoHS Article 4.1)
EN 50581
Table 18: NINA-B1 ETSI conformity
6.3 Safety Compliance
In order to fulfill the safety standard EN 60950-1, the NINA-B1 series modules must be supplied with a Class-2
Limited Power Source.
6.4 FCC and IC Compliance
6.4.1 IC compliance
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be chosen in such a way that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that is necessary for successful communication.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and
your body.
6.4.2 Conformité aux norms d´IC
Cet appareil est conforme à la(aux) norme(s) RSS sans licence d’Industry Canada.