User's Manual

LILY-W1 series - Data Sheet
UBX-15000203 - R04 Early Production Information Antennas
Page 28 of 38
Name
U.FL to Reverse Polarity SMA adapter cable
Connector
U.FL and Reverse Polarity SMA jack (outer thread and pin)
Impedance
50 Ω
Minimum cable loss
0.5 dB, The cable loss must be above the minimum cable loss
to meet the regulatory requirements
Comment
The Reverse Polarity SMA connector can be mounted in a
panel.
See LILY-W131 Antenna Connector - Reference Design [5] for
information how to integrate the U.FL connector. It is
required to followed this reference design to comply with the
LILY-W1 FCC/IC modular approvals.
Approval
FCC, IC and R&TTE
7.2 Approved antennas
7.2.1 Single band antennas
Ex-IT 2400 RP-SMA 28-001
Manufacturer
ProAnt
Polarization
Vertical
Gain
+3.0 dBi
Impedance
50 Ω
Size
Ø 12.0 x 28.0 mm
Connector
Reverse Polarity SMA plug (inner thread and pin receptacle). To be mounted on the U.FL to
Reverse Polarity SMA adapter cable.
Comment
This antenna requires to be mou ted on a metal ground plane for best performance.
An SMA version antenna is also available but not recommended for use (Ex-IT 2400 SMA 28-
001).
Approval
FCC, IC, and R&TTE
ANT-2.4-CW-RH-RPS
Manufacturer
Linx
Polarization
Vertical
Gain
-1.0 dBi
Impedance
50 Ω
Size
Ø 7.4 x 27.0 mm
Connector
Reverse Polarity SMA plug (inner thread and pin receptacle). To be mounted on the U.FL to
Reverse Polarity SMA adapter cable.
Comment
An SMA version antenna is also available but not recommended for use (ANT-2.4-CW-RH-
SMA).
Approval
FCC, IC, and R&TTE