User's Manual

LILY-W1 series - Data Sheet
UBX-15000203 - R04 Early Production Information Qualification and approvals
Page 26 of 38
6.4.4 Labeling requirements for end product
For an end product using the LILY-W1 modules there must be a label containing, at least, the following
information:
This device contains
FCC ID: XPYLILYW1
IC: 8595A-LILYW1
The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection in
compliance with the modular approval guidelines developed by the FCC.
In accordance with 47 CFR § 15.19, the end product shall bear the following statement in a conspicuous
location on the device:
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation."
When the device is so small or for such use that it is not practicable to place the statement above on it, the
information shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user
or, alternatively, shall be placed on the container in which the device is marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the FCC ID
and/or this statement, the FCC ID and the statement shall also be included in the end-product manual.
6.4.5 FCC and IC IDs
Model
FCC ID
IC ID
LILY-W131
XPYLILYW1
8595A-LILYW1
LILY-W132
XPYLILYW1
8595A-LILYW1
Table 19: FCC and IC IDs for different models of the LILY-W1 series