User's Manual

LILY-W1 series - Data Sheet
UBX-15000203 - R04 Early Production Information Qualification and approvals
Page 25 of 38
2. il doit accepter toutes interférences reçues, y compris celles susceptibles d’avoir des effets indésirables
sur son fonctionnement.
Conformément aux réglementations d’Industry Canada, cet émetteur radio ne peut fonctionner qu’à l’aide
d’une antenne dont le type et le gain maximal (ou minimal) ont été approuvés pour cet émetteur par Industry
Canada. Pour réduire le risque d’interférences avec d’autres utilisateurs, il faut choisir le type d’antenne et son
gain de telle sorte que la puissance isotrope rayonnée équivalente (p.i.r.e) ne soit pas supérieure à celle requise
pour obtenir une communication satisfaisante.
Cet équipement respecte les limites d’exposition aux rayonnements IC RSS-102 définies pour un environnement
non contrôlé. Il doit être installé et utilisé en maintenant une distance minimum de 20 cm entre le radiateur et
votre corps.
6.4.3 FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
The LILY-W1 module is for OEM integrations only. The end-user product will be professionally installed in such a
manner that only the authorized antennas are used.
For LILY-W131 is an external antenna connector (U.FL. connector) reference design (see LILY-W131 Antenna
Connector - Reference Design [5]) available and must be followed to comply with the LILY-W1 FCC/IC modular
approval.
Any changes or modifications NOT explicitly APPROVED by u-blox could cause the module to cease to comply
with FCC rules part 15, and thus void the user's authority to operate the equipment.
6.4.3.1 Cautions
Any changes or modifications could cause the module to cease to comply with
FCC rules part 15 and thus void the user's authority to operate the equipment.
§15.407 statement; in case of absence of information to transmit or operational failure, the
LILY-W1 module will automatically discontinue transmission.