User's Manual

LILY-W1 series - Data Sheet
UBX-15000203 - R04 Early Production Information Qualification and approvals
Page 24 of 38
6 Qualification and approvals
6.1 Approvals
The LILY-W1 series modules comply with the "Directive 2011/65/EU of the European Parliament and
the Council on the Restriction of Use of certain Hazardous Substances in Electrical and Electronic
Equipment" (RoHS).
LILY-W1 series modules are RoHS compliant. No natural rubbers, hygroscopic materials, or materials
containing asbestos are employed.
6.2 European Union regulatory compliance
The LILY-W1 module conforms to the product specifications listed in Table 18. See the LILY-W1 Declaration of
Conformity [4] for more information.
Category
Standard
R&TTE Directive 1999/5/EC
Effective use of frequency spectrum
EN 300 328 V1.9.1
EMC
EN 301 489-1
EN 301 489-17
Health and safety
EN 60950-1 / IEC 60950-1
EN 62311
EN 62479
Medical Electrical Equipment
EN 60601-1-2
Prevention (RoHS Article 4.1)
EN 50581
Table 18: LILY-W1 ETSI conformity
6.3 Safety Compliance
In order to fulfill the safety standard EN 60950-1, the unit must be supplied by a limited power source.
6.4 FCC and IC Compliance
6.4.1 IC compliance
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be chosen in such a way that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that is necessary for successful communication.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and
your body.
6.4.2 Conformité aux normes d’IC
Cet appareil est conforme à la(aux) norme(s) RSS sans licence d’Industry Canada.
Son utilisation est soumise aux deux conditions suivantes :
1. Cet appareil ne doit pas causer d’interférences et