Installation Manual

CAS-GPS IVU BASIC SYSTEMS INSTALLATION MANUAL DOCU0085 Revision Q

General Wiring Principles

• Blanking plugs or caps are supplied and must be in place for all unused connectors i.e. 24 way Deutsch

Connector on the IVU for example

• All cable joins/splices should be soldered and heat shrink insulation applied

• All wires are to be labelled i.e. IGN, VIN+ ,GND , REV using the supplied labels

• DO NOT use clamp type splice devices to tee into vehicle wiring

• Crimp type ring terminals should be used for all terminal blocks

• All wiring should be run in the supplied flexible conduit along with the boot ends also supplied in the kit

• Ethernet connections made to an IVU must be of a shielded construction