Installation Manual

CAS-GPS IVU BASIC SYSTEMS INSTALLATION MANUAL DOCU0085 Revision Q

• Follow existing cable runs where possible.

• All cables to be secured using P-Clamps where possible.

• Cable ties should be used as a last resort where there is no provision for P-Clamps Ensure cable ties are

cut flush to avoid sharp edges.

• Cables should be secured at a minimum every 300mm.

• Cabling must be kept away from air bags, fire extinguishers & suppression systems in accordance with

local regulations.

• Avoid running cables near hot spots and pinch points.

• Glands should be used on cables running through bulkheads.

• It is recommended that a service loop be created on all the Antenna Coax Cables this will especially aid

in servicing of the system. i.e. Break in termination at either end of the Coax cables.

• Service loops are acceptable in the Coax and Display cables. Ensure if a service loop is placed in the

Coax Antenna cable that it is placed in a position that it is not going to create a hazard, also ensure the

service loop radius is not to small.

• If mounting through a blind panel the supplied Nutserts should be used to enable easy removal for

servicing.

Mounting Locations & Cable Runs