Data Sheet

JODY-W2 series - Data sheet
UBX-18017567 - R07 Approvals Page 31 of 46
C1 - Public
MHz et 5650-5850 MHz et que ces radars pourraient causer des interférences et / ou des
dommages à dispositifs LAN-EL.
L’étiquette d’homologation d’ISED d’un module donné doit être posée sur l’appareil hôte à un endroit
bien en vue en tout temps. En l’absence d’étiquette, l’appareil hôte doit porter une étiquette sur
laquelle figure le numéro d’homologation du module d’ISED, précédé des mots « Contient un module
d’émission », ou du mot « Contient », ou d’une formulation similaire allant dans le même sens et qui va
comme suit : « Contient le module d’émission IC: 8595A-JODYW263 ».
This radio transmitter IC: 8595A-JODYW263 has been approved by ISED to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for
use with this device.
Le présent émetteur radio IC: 8595A-JODYW263 a été approuvé par ISED pour fonctionner avec les
types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non
inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur.
The internal / external antenna(s) used for this module must provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
☞ The approval type for all the JODY-W2 series variants is a single modular approval. Due to ISED
Modular Approval Requirements (Source: RSP-100 Issue 10), any application which includes the
module must be approved by the module manufacturer (u-blox). The application manufacturer
must provide design data for the review procedure.
7.4 Certification in other countries
Additional country certifications can be progressed upon request. For further information, contact
the support team for your area, as listed in the Contact section.
7.5 Approved antennas
7.5.1 Wi-Fi / Bluetooth dual band antennas
For Bluetooth and Wi-Fi operation in the 2.4 GHz band and Wi-Fi operation in the 5 GHz band, the
module has been tested and approved for use with the antennas listed in Table 29.
Manufacturer Part Number Antenna type Peak gain [dBi] Validated
Regulatory Domain
2.4 GHz band 5 GHz band
Linx ANT-DB1-RAF-RPS Dual-band dipole antenna [6] 2.5 4.6 FCC/ISED, ETSI
Table 29: List of approved dual-band antennas
⚠ Important: To be compliant to FCC §15.407(a) the EIRP is not allowed to exceed 125 mW (21 dBm)
at any elevation angle above 30 degrees as measured from the horizon when operated as an
outdoor access point in U-NII-1 band, 5.150-5.250 GHz.
7.5.2 Bluetooth antenna
The following antennas are designated for Bluetooth transmission on JODY-W2:
Manufacturer Part Number Antenna type Peak gain [dBi]
2.4 GHz band
Validated Regulatory
Domain
Linx ANT-2.4-CW-RCT-RP Single-band dipole antenna [8] 2.2 FCC/ISED, ETSI
Table 30: List of approved single-band antennas