Data Sheet

JODY-W2 series - Data sheet

UBX-18017567 - R07 Approvals Page 28 of 46

C1 - Public

Below is the list of the FCC IDs allocated to JODY-W2 series modules.

Model

FCC ID

JODY-W263-00A, JODY-W263-01A, JODY-W263-00B XPYJODYW263

Table 27: FCC and ISED IDs for different variants of JODY-W2 series modules

7.2.1 FCC compliance statement

The JODY-W2 series modules have modular approval and comply with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

⚠ Any changes or modifications NOT explicitly APPROVED by u-blox could cause the JODY-W2

series module to cease to comply with FCC rules part 15 thus void the user's authority to operate

the equipment.

The internal / external antenna(s) used for this module must provide a separation distance of at least

20 cm from all persons and must not be co-located or operating in conjunction with any other antenna

or transmitter.

In accordance with 47 CFR § 15.19, the end product into which this module is integrated shall bear the

following statement in a conspicuous location on the device:

“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.”

When the end-product is so small or for such use that it is not practical to place the above statement

on it, the information shall be placed in a prominent location in the instruction manual or pamphlet

supplied to the user or on the container in which the device is marketed. However, the FCC ID label

must be displayed on the device.

If the end-product will be installed in locations where the end-user is not able to see the FCC ID and/or

this statement, the FCC ID and the statement shall also be included in the end-product manual.

☞ The outside of final products containing the JODY-W2 module must display in a user accessible

area a label referring to the enclosed module. This exterior label can use wording such as the

following: “Contains Transmitter Module FCC ID: XPYJODYW263” or “Contains FCC ID:

XPYJODYW263”.

7.3 Canada (ISED)

⚠ Approvals are pending.

⚠ According to ISED regulations, the transmission line from the antenna pin in the module to the

antenna or antenna connector on the host PCB is considered part of the approved antenna design.

Consequently, module integrators must follow exactly the antenna reference design used in the

module’s ISED type approval or certify their own designs. See Appendix A for details.

The model name is identical to the ordering code. Refer to Table 34 for details.