Data Sheet

BMD-380 - Data sheet
UBX-19039467 - R06 Qualification and approvals Page 28 of 36
facilities, operations or devices comply with limits for human exposure to Radio Frequency (RF) fields
adopted by the Federal Communications Commission (FCC).
This module is approved for installation into mobile and/or portable host platforms and must not be
co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter guidelines. End users must be provided with transmitter operating
conditions for satisfying RF Exposure compliance.
The BMD-380 is a self-contained transmitter module. KDB 996369 D03 Section 2.4 does not apply.
The BMD-380 is designed with a ceramic chip antenna. KDB 996369 D03 Section 2.5 does not apply.
8.2 Canada (ISED)
The BMD-380 module is certified for use in Canada under Innovation, Science and Economic
Development Canada (ISED) Radio Standards Specification (RSS) RSS-247 Issue 2 and RSSGen.
8.2.1 Labeling and user information requirements
The final host device, into which this RF Module is integrated has to be labeled with an auxiliary label
stating the IC of the RF Module, such as:
“Contains transmitter module IC: 8595A-BMD380
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device. “
Le périphérique hôte final, dans lequel ce module RF est intégré "doit être étiqueté avec une étiquette
auxiliaire indiquant le CI du module RF, tel que"
“Contient le module émetteur IC: 8595A-BMD380
Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1. L'appareil ne doit pas produire de brouillage, et
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre lefonctionnement. “
8.2.2 RF exposure
All transmitters regulated by ISED must comply with RF exposure requirements listed in RSS-102 -
Radio Frequency (RF) Exposure Compliance of Radiocommunication Apparatus (All Frequency
Bands). This module is approved for installation into mobile and/or portable host platforms and must
not be co-located or operating in conjunction with any other antenna or transmitter except in
accordance with Industry Canada's multi-transmitter guidelines. End users must be provided with
transmitter operating conditions for satisfying RF Exposure compliance.
8.3 European Union regulatory compliance
Information about regulatory compliance of the European Union for the BMD-380 module is available
in the BMD-380 Declaration of Conformity.