Data Sheet

BMD-345 - Data sheet
UBX-19039908 - R07 Qualification and approvals Page 28 of 36
All transmitters regulated by FCC must comply with RF exposure requirements. KDB 447498 General
RF Exposure Guidance provides guidance in determining whether proposed or existing transmitting
facilities, operations or devices comply with limits for human exposure to Radio Frequency (RF) fields
adopted by the Federal Communications Commission (FCC).
This module is approved for installation into mobile host platforms and must not be co-located or
operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-
transmitter guidelines. End users must be provided with transmitter operating conditions for
satisfying RF Exposure compliance.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment shall be installed and operated with minimum distance 20cm between the radiator &
body.
KDB 996369 D03 sections 2.4 (limited module procedures) and 2.5 (trace antenna designs) are not
applicable to the BMD-345.
9.2 Canada (ISED)
The BMD-345 module is certified for use in Canada under Innovation, Science and Economic
Development Canada (ISED) Radio Standards Specification (RSS) RSS-247 Issue 2 and RSSGen.
9.2.1 Labeling and user information requirements
The BMD-345 is assigned the IC ID number: 8595A-BMD345
The final host device, into which this RF Module is integrated has to be labeled with an auxiliary label
stating the IC of the RF Module, such as:
“Contains transmitter module IC: 8595A-BMD345
“This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.”
Le périphérique hôte final, dans lequel ce module RF est intégré "doit être étiqueté avec une étiquette
auxiliaire indiquant le CI du module RF, tel que" Contient le module émetteur IC: 8595A-BMD345
“L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L'appareil ne doit pas produire de brouillage, et
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre lefonctionnement.“
9.2.2 RF exposure / Déclaration d'exposition aux radiofréquences
The device has been evaluated to meet general RF exposure requirements. The device can be used in
mobile exposure conditions. The min separation distance is 20cm.
L'appareil a été évalué pour répondre aux exigences générales en matière d'exposition aux RF.
L'appareil peut être utilisé dans des conditions d'exposition mobiles. La distance de séparation
minimale est de 20 cm.