Integration Manual

ANNA-B4 series - System integration manual
UBX-21000517 - R03 Contents Page 59 of 76
C1-Public
8 Pre-approved antennas list
This chapter lists the external antennas that are pre-approved for use together with ANNA-B4 series
modules.
☞ Note that not all antennas are approved for use in all markets/regions.
☞ This radio transmitter [IC: 8595A-ANNAB4] has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Cet émetteur radio [IC: 8595A-ANNAB4] a été approuvé par Innovation, Sciences et
Développement économique Canada pour fonctionner avec les types d'antenne énumérés ci-
dessous, avec le gain maximal admissible indiqué. Les types d'antenne non inclus dans cette liste
qui ont un gain supérieur au gain maximum indiqué pour tout type répertorié sont strictement
interdits pour une utilisation avec cet appareil.
⚠ Approvals are pending
8.1 Approved antennas
AT1608-A2R4NAA - ANNA-B4 internal antenna
Gain
+0.5 dBi
Comment
Internal antenna on ANNA-B4.
The intenal antenna should not be mounted inside a metal enclosure.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, ACMA and ICASA
FXP75.07.0045B
Manufacturer
Taoglas
Gain
+2.5 dBi
Impedance
50 Ω
Size
5.9 x 4.1 x 0.24 mm
Type
Patch, Flexfilm
Connector
U.FL.
Cable length
45 mm
Comment
For best performance, this antenna should be attached to a plastic enclosure
or part. It should be mounted on a U.FL connector and not inside a metal
enclosure. For more information, see antenna data sheet.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, ACMA and ICASA
FXP74.07.0100A
Manufacturer
Taoglas
Gain
+4.0 dBi
Impedance
50 Ω
Size
47.0 x 7.0 x 0.1 mm
Type
Patch, Flexfilm