Integration Manual

ANNA-B4 series - System integration manual
UBX-21000517 - R03 Contents Page 54 of 76
C1-Public
The following statement must be included in the end-user manual or guide:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC and IC IDs
Model
FCC ID
IC
ANNA-B402
FCC ID: XPYANNAB4
IC: 8595A-ANNAB4
ANNA-B412
FCC ID: XPYANNAB4
IC: 8595A-ANNAB4
Table 20: FCC ID and IC for the ANNA-B4 modules
End product compliance
7.3.6.1 General requirements
• Any changes to hardware, hosts or co-location configuration may require new radiated
emission and SAR evaluation and/or testing.
• Only authorized antenna(s) may be used.
• Any notification to the end user about how to install or remove the integrated radio module is
NOT allowed.
• The modular transmitter approval of ANNA-B4 does not exempt the end product from being
evaluated against applicable regulatory demands. The evaluation of the end product shall be
performed with the ANNA-B4 module installed and operating in a way that reflects the
intended end product use case. The upper frequency measurement range of the end product
evaluation is the 5th harmonic of 2.4 GHz as declared in 47 CFR Part 15.33 (b)(1).
• The following requirements apply to all products that integrate a radio module:
o Subpart B - UNINTENTIONAL RADIATORS
To verify that the composite device of host and module complies with the
requirements of FCC part 15B the integrator shall perform sufficient measurements
using ANSI 63.4-2014.
o Subpart C - INTENTIONAL RADIATORS
It is required that the integrator carry out sufficient verification measurements using
ANSI 63.10-2013 to validate that the fundamental and out of band emissions of the
transmitter part of the composite device complies with the requirements of FCC part
15C.
• When the items listed above are fulfilled the host manufacturer can use the authorization
procedures presented in Table 1 of 47 CFR Part 15.101.