Integration Manual

ANNA-B4 series - System integration manual
UBX-21000517 - R03 Contents Page 53 of 76
C1-Public
End product labeling requirements
7.3.4.1 ISED Compliance
The host product shall be properly labelled to identify the modules within the host product.
The Innovation, Science and Economic Development Canada certification label of a module shall be
clearly visible at all times when installed in the host product; otherwise, the host product must be
labelled to display the Innovation, Science and Economic Development Canada certification number
for the module, preceded by the word “Contains” or similar wording expressing the same meaning,
as shown in Figure 26.
Le produit hôte devra être correctement étiqueté, de façon à permettre l’identification des modules
qui s’y trouvent.
L’étiquette d’homologation d’un module d’Innovation, Sciences et Développement économique
Canada devra être posée sur le produit hôte à un endroit bien en vue, en tout temps. En l’absence
d’étiquette, le produit hôte doit porter une étiquette sur laquelle figure le numéro d’homologation du
module d’Innovation, Sciences et Développement économique Canada, précédé du mot « contient »,
ou d’une formulation similaire allant dans le même sens et qui va comme suit:
This device contains
FCC ID: XPYNINAB4
IC: 8595A-ANNAB4
Figure 26: Example of an end product label
7.3.4.2 FCC Compliance
For an end product that uses the ANNA-B4 modules, there must be a label containing, at least, the
information shown in Figure 26.
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
☞ In accordance with 47 CFR § 15.19, the end product shall bear the following statement in a
conspicuous location on the device:
"This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation."
When the device is so small or for such use that it is not practicable to place the statement above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is
marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the
end product manual.