Integration Manual

ANNA-B4 series - System integration manual
UBX-21000517 - R03 Contents Page 52 of 76
C1-Public
RF-exposure statement
7.3.2.1 ISED Compliance
This equipment complies with the requirements of IC RSS-102 issue 5 radiation exposure limits set
forth for an uncontrolled environment.
☞ Having a separation distance of minimum 20 mm between the user and/or bystander and the
antenna and /or radiating element ensures that the output power (EIRP.) of ANNA-B5 is below the
SAR evaluation Exemption limits defined in RSS-102 issue 5 (Canadian market limits).
7.3.2.2 FCC Compliance
This device complies with the FCC radiation exposure limits set forth for an uncontrolled environment.
☞ The maximum output power of ANNA-B4 is below the SAR test exclusion limits presented in KDB
447498 D01v06 applicable for separation distances between 0 mm and 5 mm. Therefore, SAR
evaluation is not needed.
KDB 996369 D03 section 2.4 (limited module procedures) is not applicable to the ANNA-B4 series
modules.
KDB 996369 D03 section 2.5 (trace antenna designs) is not applicable to the ANNA-B4 series
modules.
End product user manual instructions
7.3.3.1 ISED Compliance
The ANNA-B4 module is certified for use in Canada under Innovation, Science and Economic
Development Canada (ISED) Radio Standards Specification (RSS) RSS-247 Issue 2 and RSSGen. The
host product shall be properly labelled to identify the modules within the host product.
☞ The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary
label stating the IC of the RF Module, such as" Contains transmitter module IC: 8595A-ANNAB4
☞ Le périphériquehôte final, danslequelce module RF estintégré "doitêtreétiqueté avec
uneétiquetteauxiliaireindiquant le CI du module RF, tel que" Contient le module émetteur IC:
8595A-ANNAB4
☞ This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
☞ L’émetteur/récepteur exempt de licencecontenudans le présentappareilestconforme aux CNR
d’Innovation, Sciences et Développementéconomique Canada applicables aux appareils radio
exempts de licence. L’exploitationestautorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d' encompromettre le fonctionnement.