Integration Manual

SARA-R4/N4 series - System Integration Manual
UBX-16029218 - R13 Approvals Page 101 of 119
⚠
⚠⚠
⚠ The gain of the system antenna(s) used for the SARA-R4/N4 series modules (i.e. the combined transmission line,
connector, cable losses and radiating element gain) must not exceed the value stated in the ISED Canada Grant for
mobile and fixed or mobile operating configurations:
• SARA-R410M-01B modules:
o 3.67 dBi in 700 MHz, i.e. LTE FDD-12 band
o 4.10 dBi in 850 MHz, i.e. LTE FDD-5 band
o 6.74 dBi in 1700 MHz, i.e. LTE FDD-4 band
o 7.12 dBi in 1900 MHz, i.e. LTE FDD-2 band
• SARA-R410M-02B, SARA-R410M-52B and SARA-N410-02B modules:
o 3.66 dBi in 700 MHz, i.e. LTE FDD-12 band
o 3.94 dBi in 750 MHz, i.e. LTE FDD-13 band
o 4.41 dBi in 850 MHz, i.e. LTE FDD-5 band
o 6.75 dBi in 1700 MHz, i.e. LTE FDD-4 band
o 7.00 dBi in 1900 MHz, i.e. LTE FDD-2 band
• SARA-R412M-02B modules:
o 5.63 dBi in 700 MHz, i.e. LTE FDD-12 band
o 5.94 dBi in 750 MHz, i.e. LTE FDD-13 band
o 6.12 dBi in 850 MHz, i.e. GSM 850 / LTE FDD-5 band
o 8.29 dBi in 1700 MHz, i.e. LTE FDD-4 band
o 8.52 dBi in 1900 MHz, i.e. GSM 1900 / LTE FDD-2 band
4.3.2 Modifications
ISED Canada requires the user to be notified that any changes or modifications made to this device that are not expressly
approved by u-blox could void the user's authority to operate the equipment.
⚠
⚠⚠
⚠ Manufacturers of mobile or fixed devices incorporating the SARA-R4/N4 series modules are authorized to use the
ISED Canada Certificates of the SARA-R4/N4 series modules for their own final products according to the conditions
referenced in the certificates.
⚠
⚠⚠
⚠ The ISED Canada Label shall in the above case be visible from the outside, or the host device shall bear a second label
stating:
o For SARA-R410M and SARA-N410 modules: "Contains IC: 8595A-2AGQN4NNN"
o For SARA-R412M cellular modules: "Contains IC: 8595A-UBX18ZO01"
⚠
⚠⚠
⚠ Innovation, Science and Economic Development Canada (ISED) Notices
This Class B digital apparatus complies with Canadian CAN ICES-3(B) / NMB-3(B).
Operation is subject to the following two conditions:
• this device may not cause interference
• this device must accept any interference, including interference that may cause undesired operation of the
device
Radio Frequency (RF) Exposure Information
The radiated output power of the u-blox Cellular Module is below the Innovation, Science and Economic
Development Canada (ISED) radio frequency exposure limits. The u-blox Cellular Module should be used in a manner
such that the potential for human contact during normal operation is minimized.
This device has been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions
(antennas are greater than 20 cm from a person's body).
This device has been certified for use in Canada. Status of the listing in the Industry Canada’s REL (Radio Equipment
List) can be found at the following web address:
http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch.do?lang=eng