Integration Manual

SARA-R4/N4 series - System Integration Manual
UBX-16029218 - R13 Approvals Page 100 of 119
4.2.3 Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly
approved by u-blox could void the user's authority to operate the equipment.
⚠
⚠⚠
⚠ Manufacturers of mobile or fixed devices incorporating the SARA-R4/N4 series modules are authorized to use the
FCC Grants of the SARA-R4/N4 series modules for their own final products according to the conditions referenced in
the certificates.
⚠
⚠⚠
⚠ The FCC Label shall in the above case be visible from the outside, or the host device shall bear a second label stating:
o For SARA-R404M modules: "Contains FCC ID: XPY2AGQN1NNN"
o For SARA-R410M and SARA-N410 modules: "Contains FCC ID: XPY2AGQN4NNN"
o For SARA-R412M cellular modules: "Contains FCC ID: XPYUBX18ZO01"
⚠
⚠⚠
⚠ IMPORTANT: Manufacturers of portable applications incorporating the SARA-R4/N4 series modules are required to
have their final product certified and apply for their own FCC Grant related to the specific portable device. This is
mandatory to meet the SAR requirements for portable devices.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
⚠
⚠⚠
⚠ Additional Note: as per 47CFR15.105 this equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
o Reorient or relocate the receiving antenna
o Increase the separation between the equipment and receiver
o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
o Consultant the dealer or an experienced radio/TV technician for help
4.3 Innovation, Science, Economic Development Canada notice
ISED Canada (formerly known as IC - Industry Canada) Certification Numbers:
• u-blox SARA-R410M and SARA-N410 cellular modules: 8595A-2AGQN4NNN
• u-blox SARA-R412M cellular modules: 8595A-UBX18ZO01
4.3.1 Declaration of Conformity
This device complies with the ISED Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
• this device may not cause harmful interference
• this device must accept any interference received, including interference that may cause undesired operation
⚠
⚠⚠
⚠ Radiofrequency radiation exposure information: this equipment complies with the radiation exposure limits
prescribed for an uncontrolled environment for fixed and mobile use conditions. This equipment should be installed
and operated with a minimum distance of 20 cm between the radiator and the body of the user or nearby persons.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except as
authorized in the certification of the product.