User's Manual

RT27 True Wireless Earbuds

USER MANUAL

BLUETOOTH PARING INSTRUCTION

1. Remove both earbuds from the charging case. They will begin auto-pairing to

each other. You will hear 2 beeps and a “pairing” voice prompt to confirm a

successful pairing.

2. Keep the earbuds within 3 feet of your smart device(for Bluetooth pairing

only). Enable your device’s Bluetooth function from your device’s settings

menu. Select” RT27” from the Bluetooth device list to pair the earbuds to

your device.

3. You will hear “device connected” Indicating that TWS are now ready to use.

4. Each earbud can be used independently.

Resetting your TWS

If your TWS won’t pair to each other, place them back in the charging case.

When you pick up them and it will auto-pair.

FUNCTIONS

Power on: Pick up two earbuds from charging case

Power off: Put back two earbuds into charging case.

MUSIC/CALL

1. Previous/Next song

Press and hold the Left/Right earbud button for 2 seconds.

2. Play/pause

Press the right/left earbud once to play/pause music.

3. Answer /End an incoming call

Press the right/left earbud once to answer a call, and press again when you

want to end the call.

4. Voice Assistant: Press the Right/Left earbud button twice to active/exit the Voice

Assistant/Siri function. This function may not work with all devices.

PAGE 1
RT27 True Wireless Earbuds USER MANUAL BLUETOOTH PARING INSTRUCTION 1. Remove both earbuds from the charging case. They will begin auto-pairing to each other. You will hear 2 beeps and a “pairing” voice prompt to confirm a successful pairing. 2. Keep the earbuds within 3 feet of your smart device(for Bluetooth pairing only). Enable your device’s Bluetooth function from your device’s settings menu. Select” RT27” from the Bluetooth device list to pair the earbuds to your device. 3.
PAGE 2
CHARGING (Be sure fully charge the TWS before using for the first time.) Charging the case: When the white LED light on the bottom of the case quickly flashes. The case is low on power and must be charged. Plug the Micro-USB cable into the bottom of the case to charge it. The LED will flash green while charging. Once fully charged, LED will glow solid green. Charging the earbuds: When the earbuds are low in power, you will hear “low power”. Place the earbuds into their respective slots in the charging case.
PAGE 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.