User's Manual

USER'S MANUALUSER'S MANUAL

MIC / SP

使用说明书

USER

'S MANUALUSER'S MANUAL

Basic operation

1 Scan Function

When the radio is allowed to be scanned, which can be set by the software. you can press

the PTT key to turn on or turn off the scan. When the scan begins.indicators lights green.

the radio will can scan automatically from channel 1 to 16 which is defined as scan added.

When there is signal in the scanning channel, it will stop in the channel for talk.

Note:

When there is signal in the scanning channel, it will stop in the channel for a talk and after

several seconds.

Please note that scan is only available when there are two or more than two memory

channels and two or more scan added channels

2. Battery Save Function

This function can be set by the software.

Turn on this function can make the standby time more longer.

3. Scrambler

When the radio is allowed the scrambler function. and press the key. TX voice will be

sent out with scrambler. other radio only received the signal when its scrambler also

turns on.

4 Busy Channel Lock

You can turn on/off this function via software.

A: if the current channel does not have CTCSS/DCS, When there is signal. TX prohibited

when you press PTT.

Getting Familiar

Scanning Receiver

PAGE 1
Getting Familiar MIC / SP is USER'S MANUAL Scanning Receiver Basic operation 1 Scan Function When the radio is allowed to be scanned, which can be set by the software. you can press the PTT key to turn on or turn off the scan. When the scan begins.indicators lights green. the radio will can scan automatically from channel 1 to 16 which is defined as scan added. When there is signal in the scanning channel, it will stop in the channel for talk.
PAGE 2
B: If the current channel does not have CTCSS/DCS. when there is signal which does not have CTCSS/DCS. TX prohibited vvhen you press PTT. C: If the current channels does not have CTCSS/DCS. vvhen there is signal which have CTCSS/DCS. the radio will transmit when you press PTT. 5. Wide/Narrow Bandwidth Setting 1 ) The voice prompt can be selected "Chinese/English/Tone/OFF" through the menu "Voice/Beep Tone" of the "Optional Features" in the software for. When choosing "OFF", voice prompt turns off.
PAGE 3
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.