Instructions

Then it will display SET TIRE ID TRUCK HEAD and
your selected Layout will be shown.
Now insert a battery into the new sensor.
The Monitor will beep once the battery is
inserted and the wheel location on the monitor
will go solid black. Repeat this step for the rest
of the new sensors until they are all
programmed in.
Note: You only need to do this for the new sensors,
the old original sensors will be already
programmed in.
Once all new sensors are programmed in, press
the reset button on the relay once (short press)
and the LED on the relay will turn off to exit
learning mode.
Now either switch the monitor OFF and ON using the switch on the side of the monitor.
Or
Press the Backlight (Right) button then the Temperature (Middle) button to exit the menu on the
monitor.
Test all sensors are working and programmed and set the Alarm Warning Thresholds if required.