Instructions

Press the Mute (Left) button to scroll across to
menu D (Add new Relay).
Press the Backlight (Right) button to enter this
menu.
PUSH BUTTON ON RELAY TRUCK HEAD your
current Layout No. will be displayed.
Now Press the reset button on the relay once
(short press only).
The Monitor will beep and will briefly show an
ID for the relay for a couple of seconds.
Now press the Backlight (Right Button) and this
will take you back to the settings menu.
The New Layout has now been saved to the Monitor and Relay and you can now program in the new
sensors.
Step 2: Programming new Sensors.
Press the Mute (Left) button to scroll across to
menu E (Add new Sensor).
Press the Backlight (Right) button to enter this
menu.
SET TIRE ID
PUSH BUTTON ON RELAY will be displayed.
Now Press the reset button on the relay once
(short press only).
The Monitor will beep and will briefly show an
ID for the relay for a couple of seconds.
The LED on the relay will also illuminate solid
red to indicate the relay is in Learning mode.
ID: 0012A6