Instruction Manual

ManualsBrandsTycon Power ManualsPower suppliersRPST-PowerVent

RPST-PowerVent

Power Enclosure

Ventilator

▫ ENC-ST Enclosures

▫ RPST Systems

▫ UPS-ST Systems

Congratulations! on your purchase of the RPST-PowerVent.

Please take a moment to review this Qwik Install Guide before

installation to the Enclosure.

Recommended Tools: Phillips Screwdriver

Qwik Install

STEP 0: The RPST-PowerVent replaces the bottom access plate in the

ENC-ST steel enclosure.

STEP 1: Remove the 8 screws from the existing access plate and re-

move the existing access plate. Remove the cable glands and hole

plugs from the existing plate.

STEP 2: Assemble cable glands and hole plugs to the RPST-

PowerVent plate.

STEP 3: Install the RPST-PowerVent to the enclosure with the fan on

the left side. Tighten 8 screws loosely and then tighten to seal the gas-

ket against the bottom of the enclosure. Don’t over tighten or plate will

be bent and gasket seal won’t work properly.

STEP 4: Route red and black wires to a 12VDC power source. Connect

red wire to V+ and black wire to V-.

Summary of content (4 pages)

PAGE 1
RPST-PowerVent Power Enclosure Ventilator ▫ ENC-ST Enclosures ▫ RPST Systems ▫ UPS-ST Systems Congratulations! on your purchase of the RPST-PowerVent. Please take a moment to review this Qwik Install Guide before installation to the Enclosure. Recommended Tools: Phillips Screwdriver Qwik Install STEP 0: The RPST-PowerVent replaces the bottom access plate in the ENC-ST steel enclosure. STEP 1: Remove the 8 screws from the existing access plate and remove the existing access plate.
PAGE 2
SPECIFICATIONS Voltage Requirements Power Requirements Power Connection Fan Air Volume Filter Mesh x 2 Cable Ports Mounting Operating Temperature Humidity (RH) Dimensions (LxWxH) Weight 12VDC 1W @ 12VDC – when temperature over 50C (122F) 1 meter 22AWG 2 Conductor red/black wire 14 CFM min Stainless Mesh - 0.050” Openings 20mm holes x 4 for Cable Gland 8 Existing Screws in Enclosure Bottom Plate -30C to +65C (-22F to 149F) 5% - 95% (non-condensing) 330 x 91.4 x 38mm (13” x 3.6” x 1.
PAGE 3
generating heat, the fan may run longer to compensate for the internal heating. 3. FILTER MESH: The stainless steel filter mesh should be small enough to keep out most insects but will allow dust to enter. If the unit will be used in dusty areas, we recommend adding a dust cover over the existing filter mesh. A square piece of filter material can be cut and fastened over the existing filter mesh using Velcro.
PAGE 4
Limited Warranty The RPST-PowerVent products are supplied with a limited 24 month warranty which covers material and workmanship defects. This warranty does not cover the following: ▫ Parts requiring replacement due to improper installation, misuse, poor site conditions, faulty power, etc. ▫ Lightning or weather damage. ▫ Physical damage to the external & internal parts. ▫ Products that have been opened, altered, or defaced. ▫ Water damage for units that were not mounted according to user manual.