User guide

STEP 7: Tighten the RJ45 Feedthru on the cable. If the cable diam-

eter is too small to make a good seal, wrap a couple turns of electrical

tape around the CAT5 cable at the seal area to increase it’s diameter.

STEP 8: Make sure lid gasket is clean and free from any particles,

then carefully close the cover, making sure that wires are clear of the

seam and hinge area.

STEP 9: Tighten the 4 seal screws evenly to seal the cover. Use a

grease or oil on the 4 cover attached screws to make it easier to re-

move later.

TECH CORNER

Additional Information you may find useful

1. CONTROLLER: The controller turns off power to the load at 11V and

reconnects when the battery reaches 12V. This protects battery from

over-discharge and increases battery life and performance.

2. CAPACITY: The RemotePro RPDC12-9-10 is rated at 2.5W contin-

uous power output with 6 hours of peak sun per day. Reserve battery

capacity at 2.5W load is 36 hours. The RPDC12-9-05 is rated at 1.25W

continuous power.

3. VENTING: The enclosure is vented thru a Goretex Vent in the bot-

tom of the enclosure. Don’t cover this vent.

Limited Warranty

The RemotePro™ products are supplied with a limited 24 month war-

ranty which covers material and workmanship defects. This warranty

does not cover the following:

▫ Parts requiring replacement due to improper installation, misuse,

poor site conditions, faulty power, etc.

▫ Lightning or weather damage.

▫ Physical damage to the external & internal parts.

▫ Products that have been opened, altered, or defaced.

▫ Water damage for units that were not mounted according to user

manual.

▫ Usage other than in accordance with instructions and the normal

intended use.