Operator's Manual

MM101332V1, Rev. K

2. Overdial numbers are transmitted by entering the phone mode using the  button.

Press

 to enter the overdial select/entry mode and follow the selection mode rules to call up a stored

number from the phone list.

is displayed. Press PTT to send the overdial sequence once. If the number

needs to be transmitted again it must be selected or entered again (this prevents unwanted numbers from

being sent the next time the PTT button is pressed during the call). This overdial select/entry mode

remains active until the call is dropped, cleared, or

 is pressed. The overdial select/entry mode can be

re-entered if the call is still active by pressing

.

SYSTEM MODEL

1. Follow the procedure in Section 11.5.2 to establish a connection to the telephone system or consult

the system administrator for the procedure to access a dial tone on the trunked or conventional

system.

2. Overdial numbers are transmitted using either method as follows:

This overdial select/entry mode remains active until dropped, cleared, or

 is pressed. The overdial

select/entry mode can be re-entered if the call is still active by pressing

.

11.6 PROGRAMMABLE ENTRIES

11.6.1 Pre-Storing Individual and Telephone Interconnect Calls from the

Keypad

Individual Call ID numbers, telephone numbers and other number sequences for overdialing are stored in

the special calls lists when programming the radio. The first ten entry locations of these lists can be

changed by the radio operator. The keypad is used when adding, changing, and storing numbers in these

entry locations.

Use the following procedure to store a number in one of the first ten entries of a special call list:

1. Press

 or  to enter the individual call list or the phone call list. is displayed.

2. Scroll through the list using the  or  until one of the first ten entries is reached. NO ENTRY is

displayed if the location is empty.

3. Enter the desired number. If necessary, a pause can be entered by pressing and holding 0-9,

, or

 until an underscore appears in the display (telephone interconnect only). The individual call list

entries will accept up to 5 digits. The phone call list entries accept a combination of up to 31 digits

and pauses.

4. Press and hold

 until the display changes indicating that the number has been stored.

Repeat steps 1-4 above if the number stored in an entry location needs to be changed.