Specifications

19
http://www.tyan.com
JP1: Clear CMOS Jumper
1
3
Normal
(Default)
1
3
Clear
Use this jumper when you forgot your system/setup
password or need to clear system BIOS setting.
How to clear the CMOS data
- Power off system and disconnect power
supply from AC source
- Use jumper cap to close Pin_2 and 3 for
several seconds to Clear CMOS
- Replace jumper cap to close Pin_1 and 2
Reconnect power supply to AC source
Power on system
JP2/JP3: COM2 Switch Jumper
3
1
Pin 1-2 Closed: COM2 (Default)
3
1
Pin 2-3 Closed: BMC UART2 to COM2
JP8: BMC Boot FW Flash Jumper
1
3
Pin 1-2 Closed: Disable
1
3
Pin 2-3 Closed: Enable (Default)
JP9: PCIE x8/x16 Select Jumper
1
3
Pin 1-2 Closed: PCIE Slot6 x16 (Default)
3
1
Pin 2-3 Closed: PCIE Slot5/6 x8
J7: PSMI Connector
1
Pin Signal Pin Signal
1 SMB_CLK 2 SMB_DAT
3 SMBALERT 4 GND
5 V3P3