Specifications

http://www.TYAN.com
69
Feature Option Description
Configure Remote Access type and parameters
Enabled
Remote Access
Disabled
Enables remote access to system
through serial port.
NOTE: The items listed below will appear when Remote Access is set to [Enabled].
COM1
Serial Port Number
COM2
Select Serial Port for console
redirection. Make sure the selected
port is enabled.
Base Address, IRQ Read only
115200 8,n,1
57600 8,n,1
38400 8, n, 1
19200 8,n,1
Serial Port Mode
9600 8,n,1
Select Serial Port settings.
None
Hardware
Software
Flow Control
Option
Select Flow Control for console
redirection.
Disabled
Boot Loader
Redirection After BIOS
POST
Always
Disable: Turns off the redirection after
POST
Boot Loader:
Redirection is active during POST and
during Boot Loader.
Always:
Redirection is always active.
<Some OSs may not work if set to
Always>
ANSI
VT100
Terminal Type
VT-UTF8
Select the target terminal type.
Enabled
VT-UTF8 Combo Key
Support
Disabled
Enable VT-UTF8 Combination key
Support for ANSI/VT100 terminals.
No Delay
Delay 1 Sec
Delay 2 Sec
Sredir Memory Display
Delay
Delay 4 Sec
Gives the delay in seconds to display
memory information