Specifications

Chapter 3: Replacing Pre-Installed
Components
3.1 Introduction
This chapter explains how to replace pre installed components including
the motherboard, LED control board, HDD, and DVD-ROM drive.
Take note of the precautions in this section when installing your system.
3.1.1
Work Area
Make sure you have a stable, clean working environment. Dust
and dirt can get into components and cause malfunctions. Use
containers to keep small components separated. Putting all small
components in separate containers prevents them from
becoming lost. Adequate lighting and proper tools can prevent
you from accidentally damaging the internal components.
3.1.2
Tools
The following procedures require only a few tools, including the
following:
z A cross head (Phillips) screwdriver
z A grounding strap or an anti-static pad
Most of the electrical and mechanical connections can be
disconnected using your fingers. It is recommended that you do
not use needle-nosed pliers to remove connectors as these can
damage the soft metal or plastic parts of the connectors.
Chapter 3:
Replacing Pre-Installed Components
31