Product Manual

TWTG R&D B.V. 2019 V1.5

Installation with adhesive

The Temperature Sensor must be placed with adhesive:

• Mounting surface is not sufficiently magnetic

• When the product is installed at 2m or higher above ground level, the adhesive should always be used

Necessities

• Sandpaper / Putty Knife

• Cleaning Supplies

• Temperature Sensor

• Adhesive

• Magnet Key (P18-023-M_KEY)

Sequence

1. If the surface is not smooth remove any irregularities using a putty knife or sandpaper

2. Clean the surface - make sure dirt and grease is removed

3. Remove the backing material from the adhesive

Continue on next page.

Fig. 15: Remove adhesive backing