User Manual
Table Of Contents
- Foreword
- About the TORPEDO PI-101 - Wall of Sound Edition
- Setting up the TORPEDO PI-101 - Wall of Sound Edition
- Configuring and using the TORPEDO PI-101 - Wall of Sound Edition
- The TORPEDO PI-101 - Wall of Sound Edition interface
- Routing of the PI-101: stereo and mono to stereo track
- Routing of the PI-101: mono track
- General controls
- Input gain and output volume controls
- Presets
- Power Amp
- Power amp, cabinet and microphone selection
- Miking
- Eq
- Exciter
- Comp
- Setup
- Wall of Sound section
- Want more cabs ?
- Hotkeys
- Technical support
- TWO NOTES AUDIO ENGINEERING Software License
Configuring and using the TORPEDO PI-101 - Wall of Sound Edition
7 Power Amp
• Power Amp: Activate the power amplifier simulation by turning "On" this
parameter.
• Master Volume: Set up the output volume of your virtual power amplifier.
• Presence: this setting affects the tube stage frequency.
• Depth: this setting affects the tube stage frequency (bandwidth).
• Pentode/Triode switch: Select how the tube is used, either in triode or in
pentode mode. Pentode mode has more headroom and volume than
triode.
• Link: activate the link function of the power amp. All the cabinets and
microphones you can choose will share the same power amp section.
This can be used in an artistic purpose or as a CPU saving optimization.
8 Power amp, cabinet and microphone selection
In this section, you can choose which simulated power amp, speaker cabinet and microphone you want to use.
You have 8 tube stage configurations, 8 microphones and over 30 speaker cabinets available. Two Notes Audio
Engineering offers new speaker cabinets available for download at http://www.two-notes.com.
Furthermore, the "User" tab gives you access to your own impulse responses (.tur files, measured with the
Torpedo Capture software), to impulse responses shared by other TORPEDO PI-101 - Wall of Sound Edition users,
or to "standard" third party impulse responses (.wav or .aiff files), either downloaded or purchased.
This function expands the sonic and creative possibilities to infinity, don’t hesitate to use audio files with no
direct link to speaker measuring, you’ll experiment totally new sonic textures.
• Amplifier list: Choose the circuit topology for the power amplifier (Push Pull
ou Single Ended) and the tube models (6L6, EL34, EL84, KT88) used by the
simulation
• Cabinet list: Determine the speaker cabinet model used for the simulation.
You can choose between guitar, bass or user cabinet (please read further
information on the user section below)..
• Microphone list: Determine the microphone model used for the simulation.
Two Notes Audio Engineering Torpedo PI-101 16