Instruction Manual

ManualsBrandsTwo Brothers Racing ManualsSensorsPolaris RZR 800

ITBR001-185

2008-10 Polaris RZR - 1

2008-10 Polaris RZR

Installation Instructions

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

FOR RACE USE ONLY

DOWNLOAD THE TOPTUNE SOFTWARE

AND LATEST MAPS FROM OUR

WEBSITE:

www.twobros.com

401 S. Grand Ave. Santa Ana, CA 92705

(800) 211-2767 www.twobros.com

PARTS LIST

1Juice Box Pro

1 USB Cable

1 Top Tune CD-ROM

1 Installation Guide

2Velcro

1 Alcohol swab

2Zip ties

Summary of content (5 pages)

PAGE 1
2008-10 Polaris RZR Installation Instructions PARTS LIST 1 1 1 1 2 1 2 Juice Box ProTM USB Cable Top Tune CD-ROM Installation Guide Velcro Alcohol swab Zip ties FOR RACE USE ONLY DOWNLOAD THE TOPTUNE SOFTWARE AND LATEST MAPS FROM OUR WEBSITE: www.twobros.com PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION 401 S. Grand Ave. Santa Ana, CA 92705 (800) 211-2767 www.twobros.
PAGE 2
Selecting the Map Position The Juice Box Pro comes loaded with up to ten maps. Using a #1 Phillips screwdriver, turn the map select dial to toggle between the loaded maps. Refer to the map position table below for the maps included in your Juice Box Pro. Using the RPM Range Dials The Low, Mid, and High RPM Dials refer to the RPM range, in thirds, of your vehicle. Each dial allows +/- 10% fuel adjustment on top of what fuel changes are done in the map.
PAGE 3
unplug connector The ignition must be turned OFF before installation. Figure A 1 2 3 Remove both seats. Remove the plastic panel behind the seats. Locate the injector harness connectors as shown in Figure A. The injector harness connectors are located next to the ignition coils. 4 Unplug the injector harness connectors. 5 Attach the Juice Box Pro connectors to the injector harness and stock wiring harness as shown in Figure B.
PAGE 4
8 Figure D 9 Attach the Juice Box Pro connectors to the TPS connector and wiring harness as shown in Figure D. Using one of the supplied zip ties, secure the connectors in place. Figure E 10 Remove the bolt securing the coil pack to the bracket as shown in Figure E. 11 Secure the ground wire from the Juice Box Pro to the bracket using the bolt removed in step 10.
PAGE 5
Figure G 13 Using one of the supplied zip ties, secure the Juice Box Pro harness to the frame as shown in Figure G. 14 Reinstall the plastic panel and seats.