User Manual

j k
l m
n o n o p o q
p
q n
p
l
o q r
s r t k
w w
A B
D
C
E
F G
------ WINGLETS ------
 Gather up the two winglet pieces
 Apply some FoamTac into the two
BEVELED cut areas
 Position the winglet as shown up
against a vertical surface and secure
so that the glue can dry and hold the
winglet in this position
 Repeat for the other winglet
 Let the glue completely dry before
handling. They should hold their
shape very nicely
 Test fit on to the end of the wing, you
may need to clean out the slots in the
winglet where they are puckered a
little from being bent up at 45 degrees
 Once you are happy with the fit,
secure to the end of the wing with
some FoamTac and use some push
pins to hold in place until dry. Repeat
for the other side