User Manual

j k
l m
n o n o p o q
p
q n
p
l
o q r
s r t k
w n
A
B
C
------ AILERON CONTROL RODS (con’t) ------
 Attach the ball link end to the aileron control horn, use a
little thread locker on the screw. Make sure the aileron is in
it’s neutral position and that the servo is electronically
center. Attach the clevis and pin to the outer most hole of
the servo control arm. Next trim the rod approx where
shown with the red dashed line
 Dress up the end of the rod as needed after cutting so that
it will slide into the brass fitting. Double check that both
the aileron and servo are centered and secure the rod and
brass fitting together with some thin CA. Be careful that
glue does not run into any unwanted areas
 Repeat for the other side
Note - In this build the ball link was put on the control
surface side. It could be the other way around, but with it
on the control surface side it will work a little smoother