User Manual

j k
l m
n o n o p o q
p
q n
p
l
o q r
s r t k
v u
A B
D
C
E
F G
------ ATTACHING WING ------

Attaching the wing is next, read thru the
steps on this and the next page to fully
understand the process before putting
glue to foam
 There are reference marks (cuts) near the
leading edge directly parallel with the
inboard end of the ailerons reliefs
 These two marks will be used as guides
when lining up the saddle area of the
fuselage with the wing
 Lay the wing on your work bench,
bottom side facing UP and test fit the
fuselage
 The wing should be all the way forward
until it is against the notch in the
fuselage saddle...
 ... and the front outside edge of the
saddle will line up with the reference
mark at the rear part of the saddle will
match up exactly to the aileron relief cut
 When you are happy with how everything
is lining up with the edges and reference
mark, apply a nice bead of FoamTac to
the saddle areas