User Manual

j k
l m
n o n o p o q
p
q n
p
l
o q r
s r t k
v v
A B
D
C
E
F G
------ TAIL CONTROL RODS ------
PART I
 Gather up two clevises, two ball links,
two small brass pins, two of the
smaller threaded brass rod ends, two
tiny screws for the ball links and two
small white spacer tubes as all shown
in the picture
 Locate the two remaining .5x500mm
rods
 Note that this build will use the clevis
links on the control surface side of
the control rod, and....
 .... the ball link end will be used on
the servo side of the control rod
 Grab two ball links and the white
spacers
 Start the spacer into the end of the
ball link
 Hold the assembly gently with a pair
of needle nose or small pliers. Ball
link pliers are shown, if you have a