User Manual

j k
l m
n o n o p o q
p
q n
p
l
o q r
s r t k
v q
A B
D
C
------ TAIL HORNS ------
 Locate the remaining two control
horns. Note - All four control horns
are exactly the same, so it does not
matter which ones you use.
 Test fit them into the slots as shown,
making sure that the hole in the horn
is directly over the hinge line at the
neutral position
 When you are happy with the fit,
remove the horn and apply some glue
to both sides of the tab
 Re-Install into the slot, making sure
that the hole in the horn is still
positioned correctly in relation to the
hinge line as mentioned in the
previous step. Repeat for the other
tail control surface.