User Manual

 
 
      

 


  
   
 _
A
B
D
C
E
------ TRUSSING ------
 Gather up two of the four long skinny
round carbon rods (1x500mm) and
the two thicker ones from the
hardware kit that are approx.
1.2x184mm long
 Cut one of the 500mm long pieces
into one each of: 121/105/98/88 mm
long pieces
 Locate the slit cuts in the fuselage
pieces that are angled to accept the
ends of the rods just cut, fill each of
the slots on one side with FoamTac
 Install the trussing as show, starting
with the longest (thick one) that goes
from the wing saddle down to the
fuselage, from there they zig-zag
towards the rear of the fuselage in
decreasing size.
 Make sure the fuselage is true, and
repeat the process for the other side
c d e
c f c
c g h
i d
d d