User Manual

 
 
      

 


  
   
 V
A B
D
C
E
F G
------ WHEEL / AXLES/ HUBS ------
 Gather up all two of the donuts with
holes in the center as pictured
 Apply some FoamTac to one side
 Join together with the piece that has
the wood hub cap all ready attached
to it, center the hole around the hub
cap. When joining together slightly
twist the two pieces to distribute the
glue
 Repeat for the other wheel
 Once both wheels are built, put them
under some heavy weights, and leave
them there overnight, this will
minimize the edges from curling up
 Locate the 3D printed axle hubs
 ... and test fit them both on to the
exposed ends of the spars as shown,
the spars may need to be shortened
slightly for a nice flush fit