User Manual

 
 
      

 


  
   
 `
A B
D
C
E
F G
------ MAIN FUSELAGE (con’t) ------
 Locate the two little white 3D printed
axle hubs
 Compare the slots in the hub to the
exposed spars
 The two should match up pretty
close, if not double check to make
sure the spar is up against the other
end of the slot
 Constrain Flat and secure with thin
CA and kicker
 Grab the remaining two spars
(.5x3x332mm) and the top half of the
other fuselage side
 Test fit them, all the way up to the
wing saddle like was done with the
other side
 Constrain flat and secure with
thin CA and kicker