User Manual

 
 
      

 


  
   
 
A B
D
C
E
F G
------ THE WING (con’t) ------
FoamTac or CA can be used to attach the
control surface horns
 Test fit the horn in to the provided
slot
 Adjust the length as needed
 Retest the fit
 Make sure the front of the horn is
flush with the edge of the hinge cut
 Apply some glue to the base of the
control horn
 Install into the slot, again making
sure that the front edge of the
horn is flush with the hinge cut.
 Repeat for the other side, paying
attention to make sure that the
other horn is installed in the same
location relative to the hinge cut