User's Manual

Octopus G Series Wireless AP
TwinMOS
Page 16
 Maximum associated stations
This the maximum number of wireless stations that can be associated at any one time.
 Fragmentation Threshold
The value defines the maximum size of packets: any packet size larger than the value will be fragmented.
If you have decreased this value and experience high packet error rates, you can increase it again, but it
will likely decrease overall network performance. Select a setting within a range of 256 to 2346 bytes.
Minor change is recommended.
 RTS Threshold
Minimum packet size required for an RTS (Request To Send). For packets smaller than this threshold,
an RTS is not sent and the packet is transmitted directly to the WLAN. Select a setting within a range of
0 to 2432 bytes. Minor change is recommended
 DTIM Interval
This is the number of beacons per DTIM (Delivery Traffic Indication Message),e.g. '1' means send a
DTIM with each beacon, '2' means with every 2nd beacon, etc.
 Maximum burst time
This is also known as PRISM Nitro (tm) technology. The technology uses fully standards-compliant
methods that eliminate collisions in mixed-mode networks, while greatly increasing the performance of
both pure 802.11g and mixed 802.11b/g networks. The setting is for the amount of time the radio will be
reserved to send data without requiring an ACK. This number is in units of microseconds. A typical
value would be 1000 microseconds. When this number is zero, bursting is disabled.