User guide

Installation 3-2 Manual 0-4686

4. Connect the cord to the input power terminal block

as shown for single or three phase. Input connec-

tions must be connected oposite the red and the

black wires. The white wire is used for 3 Phase.

Check for secure connections to the block. All cord

installations require a ground wire connection to the

power supply chassis; refer to the power supply

upper horizontal panel for proper ground wire con-

nection location.

Art # A-04670-S

Negro

Blanco

NO SE

USA

Energía

de Entrada

Monofásico,

1 alambre

rt # A-04697

Black

White

1 Phase

3 Wire

Input Power

rt # A-04652

Black

White

3 Phase

Input Power

5. Provide a small amount of slack in the cord between

the terminal block and the through-hole protector.

Tighten the through-hole protector to the cord by

hand only. Do not overtighten or use a wrench.

For 230-Volt or 460-Volt Power Supplies Only:

6. Locate the input power bus bar block on the right

side of the power supply. Position the bars accord-

ing to the input power in use.

460V Input Power

230V Input Power

Bus Bars

Art # A-04650

7. Reinstall the power supply covers. Tighten the hard-

ware securely; do not overtighten.