User guide
Table Of Contents
- 0-5143-CCr
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transtig 170Pi Power Source Controls, Indicators and Features
- 3.07 Shielding Gas Regulator Operating Instructions
- 3.08 Setup for TIG (GTAW) Welding
- 3.09 Foot Control Part No. W4015800 (Optional Accessory)
- 3.10 Setup for Manual Arc (MMAW) Welding
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- SECTION 6: KEY SPARE PARTS
- APPENDIX: TRANSTIG 170Pi CIRCUIT DIAGRAM
- CIGWELD - LIMITED WARRANTY TERMS
- TERMS OF WARRANTY – January 2013
- WARRANTY SCHEDULE – January 2013
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transmig 175i Power Source Controls, Indicators and Features
- 3.14 Shielding Gas Regulator Operating Instructions
- 3.17 Setup for TIG (GTAW) Welding
- 3.18 Setup for Manual Arc (MMAW) Welding
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- AP0-5143-APENDIX
- CIGWELD - LIMITED WARRANTY TERMS
- TERMS OF WARRANTY - JULY 2010
- WARRANTY SCHEDULE - JULY 2010
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION
TRANSTIG 170Pi
INTRODUCTION 2-6 Manual 0-5241
NOTE 4
Minimum Generator Recommendation at the Maximum Output Duty Cycle.
Due to large variations in performance and specifications of different brands and types of genera
-
tors, Cigweld cannot guarantee full welding output power or duty cycle on every brand or type of
generator.
Some small generators incorporate low cost circuit breakers on their outputs. These circuit break
-
ers usually will have a small reset button, and will trip much faster than a switchboard type circuit
breaker. This may result in not being able to achieve full output or duty cycle from the power source
/ generator combination. For this reason we recommend a generator that incorporates switchboard
type circuit breakers.
Cigweld recommends that when selecting a generator, that the particular power source / generator
combination be adequately trialled to ensure the combination performs to the users expectations.
NOTE 5
CIGWELD reserves the right to change product performance and specifications without notice.
2.11 Options and Accessories
DESCRIPTION PART NUMBER
TIG Torch 26V with 4m lead and remote control W4014604
TIG Torch accessory kit BGSAK2
Foot Control with 8m lead W4015800
Electrode Holder & Work Lead Set 8m 400A 50mm² DINSE 646325
Electrode Holder with trigger switch and 4m lead 646761
50mm² Male DINSE cable connector 704461
Naka Measurement Gauge 646265
Shielding Gas Hose Assembly, 3M W7004913
Table 2-2: Transtig 170Pi Options and Accessories